GE MDS entraNET 900, Техническое руководство

Страница: 113 / 220

05-4055A01, Rev. E MDS entraNET Technical Manual 103
4.5.1 Detailed Command Descriptions
ALARM
Displays the current alarm conditions by severity level. For each level,
the specific events that caused an alarm are listed, along with a brief
description of each alarm. Alarm levels are:
ALL
—All alarm classes
INFORM
—Non-persistent information
MINOR
—Minor alarm
MAJOR
—Major alarm
CRITICAL
—Critical alarm
Optional argument:
HEX=
—Displays the hex bit codes for the current alarm condition by
class. For each specific event that causes an alarm, the corresponding bit
is set. Event numbers are matched to the appropriate hex code by a
relationship of 2
n
.
Table 4-1. Remote Commands—Quick Reference
COMMAND DESCRIPTION COMMAND DESCRIPTION
_?
(after a com-
mand)
When entered after a command in this list,
shows detailed information and allowable
entries.
HELP Lists commands supported for the logged-in
user. See also the
?
command at the
beginning of this table.
ALARM Displays current alarm conditions by class. LOG Sets or displays the event log information.
APLIST Sets or displays serial numbers of up to 50 APs
with which the Remote can associate.
LOGIN Secure log-in. Prompts for the case-sensitive
username and password.
AUTH Sets or displays the Authorization Key and a list
of authorized features.
LOGOUT Logs the user off and ends the terminal
session.
COM1 Sets or displays the configuration of the COM1
port (baud rate, data format, buffer size,
inter-packet gap).
MESSAGE Sets the default priority level for message
packets (low, normal, high).
COM2 Sets or displays the configuration of the COM2
port (baud rate, data format, buffer size,
inter-packet gap).
PASSWORD Sets the user log-in password for the user at
the current access level or below.
CONFIG Shows the dump configuration of all settable
parameters.
PROGRAM
VERIFY
Performs a checksum verification on one of six
parameters.
DEVICE Sets or displays the device configuration,
including owner, company, and serial number.
RADIO Sets or displays the radio configuration and
status.
DIRECT
Sets or displays the configuration for direct
mode operation.
REBOOT
Restarts the radio firmware.
ENCRYPT Sets or displays the configuration for data
encryption.
SLEEP Sets the low-power operating mode: Sleep or
Shutdown.
ETH Sets or displays the Ethernet port configuration. STATS Shows radio statistics.
HANDOFF Sets or displays the hand-off configuration. STATTRACKE
R
When enabled (STATTRACKER ON), sends
UDP packets from the Ethernet port on the
Remote radio every time a wireless packet is
received.
VER
Displays the current version number.