GE MDS entraNET 900, Техническое руководство

Страница: 71 / 220

05-4055A01, Rev. E MDS entraNET Technical Manual 61
View Current Settings Screen—Unicast UDP Mode Example
Figure 3-26 shows a sample View Current Settings Screen for a system
configured for Unicast UDP mode. The selections shown are similar to
the serial-to-serial example above, but some items are UDP specific.
Invisible place holder
Figure 3-26. Serial Configuration Current Settings Screen
The following text explains the key settings for the Serial Configuration
Menu (Unicast UDP example).
•
Port Status
—This selection is used to enable or disable the
serial data port for payload data operation. Normally,
COM1
is disabled to permit Console Terminal operation.
NOTE:
When
COM1
is enabled for data, management of the radio
through
COM1
is disabled. This problem can be remedied by
typing the escape sequence + + + followed by .
This restores
COM1
to console terminal mode. You must log in
again.
•
Mode
—Used to set the method the host uses to connect to the
radio. [
Serial, Network; Network
]
•
RX IP Port
—This selection is used to specify which local IP
port address should be used to receive data from the host, as
well as the IP address and port number of the host to send
data
to at the remote end.
•
TX IP Address
—This selection is used to specify the local IP
address that will receive data from the host, as well as the IP
SHIFT ENTER