GE F35, Инструкция по эксплуатации

Страница: 527 / 682

CHAPTER 5: SETTINGS TRANSDUCER INPUTS/OUTPUTS
F35 MULTIPLE FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL 5-325
5
Hardware and software is provided to generate DCmA signals that allow interfacing with external equipment. Hardware
details are contained in chapter 3. The DCmA output channels are arranged in a manner similar to transducer input or CT
and VT channels. The user configures individual channels with the settings as follows.
The channels are arranged in sub-modules of two channels, numbered 1 through 8 from top to bottom. On power-up, the
relay automatically generates configuration settings for every channel, based on the order code, in the same manner used
for CTs and VTs. Each channel is assigned a slot letter followed by the row number, 1 through 8 inclusive, which is used as
the channel number.
Both the output range and a signal driving a given output are user-programmable via the following settings menu (an
example for channel M5 is shown).
The relay checks the driving signal (
x in equations below) for the minimum and maximum limits, and subsequently re-
scales so the limits defined as
MIN VAL
and
MAX VAL
match the output range of the hardware defined as
RANGE
. The
following equation is applied:
Eq. 5-31
where
x is a driving signal specified by the
SOURCE
setting
I
min
and I
max
are defined by the
RANGE
setting
k is a scaling constant calculated as:
Eq. 5-32
The feature is intentionally inhibited if the
MAX VAL
and
MIN VAL
settings are entered incorrectly, for example when
MAX VAL
–
MIN VAL
< 0.1 pu. The resulting characteristic is illustrated in the following figure.
Figure 5-183: DCmA output characteristic
Settings
DCMA OUTPUT H1 SOURCE
— This setting specifies an internal analog value to drive the analog output. Actual values
(FlexAnalog parameters) such as power, current amplitude, voltage amplitude, power factor, etc. can be configured as
sources driving DCmA outputs. See Appendix A for a list of FlexAnalog parameters.
DCMA OUTPUT H1 RANGE
— This setting allows selection of the output range. Each DCmA channel can be set independently
to work with different ranges. The three most commonly used output ranges are available.