GE Datex-Ohmeda S/5 Series, Техническое справочное руководство

Страница: 61 / 335

Interfacing
51
Document no. M1144951-004
E-PSM / E-PSMP. The ECG signal from the modules is channel 1 (ECG1). The channels 2 and 3
(ECG2, ECG3) are not transmitted. Make sure that the signal in channel 1 (ECG1) is good enough
(extensive QRS for IABP synchronization). For further information, please contact your
authorized GE Healthcare distributor.
Pressure out (X8 pin 4)
−
P1 from Hemodynamic Module
NOTE: With monitor software version 03 or earlier, the Invasive pressure output signal is 1
V/100 mmHg, originally ranging from 0 to 300 mmHg and with a delay of approximately 25ms.
The signal requires an input impedance of 100k.
4.7.3 S/5 Pressure Temp Module, E-PT or M-PT, output signals
The signal output connector on the Pressure Temp Module, E-PT or M-PT, can be used to
interface some models of IABPs to the S/5 Compact Anesthesia Monitor and S/5 Compact
Critical Care Monitor. The pin assignments are illustrated in
Table 13 . Please contact your local
distributor for more information.
WARNING Always make sure that the combination complies with the international
safety standard IEC 60601-1-1 for medical electrical systems and with the
requirements of local authorities.
Table 13 Signal output connector pin assignments
Output signals
ECG out, ECG1 1V / 1mV
Pressure out, P3 1V / 100mmHg
ECG out, ECG1 1V / 1mV
Pin Signal
1
2
3
4 ECG out, ECG1
Pressure out, P3
ECG out, ECG1
Ground