GE Datex-Ohmeda S/5 Series, Техническое справочное руководство

Страница: 22 / 335

Datex-Ohmeda S/5 Compact Anesthesia and Compact Critical Care Monitors
12
Document no
.
M1144951-004
•
Handle the water trap and its contents as you would any body fluid. Infectous hazard
may be present.
Accessories
•
Use only accessories, including mounts and batteries, and defibrillator-proof cables and
invasive pressure transducers approved by GE Healthcare. For a list of approved supplies
and accessories, see the “Supplies and Accessories” catalog delivered with the monitor.
Other cables, batteries, transducers and accessories may cause a safety hazard, damage
the equipment or the system, result in increased emissions or decreased immunity of the
equipment or system or interfere with the measurement. Protection against cardiac
defibrillator discharge is due in part to the accessories for pulse oximetry (SpO2),
temperature (T) and invasive pressure (P) measurement.
•
Single use accessories are not designed to be reused. Reuse may cause a risk of
contamination and/or affect the measurement accuracy.
Cautions
CAUTION A CAUTION indicates a condition that may lead to equipment damage or
malfunction.
Installation
•
Leave space for air circulation to prevent the monitor from overheating.
•
Before connecting the power cord to the power supply, check that the local voltage and
frequency correspond with the rating stated on the device plate.
Before use
•
Allow two minutes for warm-up and note any error messages or deviations from normal
operation.
•
Do not connect a sampling line to the female Patient Spirometry connector while the
other end of the sampling line is connected to the D-fend water trap. The pressure in the
gas sampling system may cause damage to the PVX unit pressure transducers.
Autoclaving and sterilizing
•
Do not autoclave any part of the monitor.
•
Do not gas sterilize the modules.
Cleaning and service
•
Do not use hypoclorite, ammonia-, phenol-, or acetone based cleaners. These cleaners
may damage the monitor surface.
•
Do not immerse any part of the device in any liquid, or allow liquid to enter the monitor or
modules.
•
Do not apply pressurized air to any outlet or tubing connected to the monitor.
•
Electrostatic discharge through the PC boards may damage the components. Before
handling PC boards, wear a static control wrist strap. Handle all PC boards by their
non-conductive edges and use anti-static containers when transporting them.
•
Do not break or bypass the patient isolation barrier when testing PC boards.
•
If liquid has accidentally entered the system or its parts, disconnect the power cord from
the power supply and have the equipment serviced by authorized service personnel.