Problems solution
106
SEER ™ 1000
2067634-131 Revision E
Bluetooth messages Microsoft Windows System
Some problems setting up the Bluetooth connection between the PC and the recorder are reported
by the PC operating system. The application attempts to propose a solution, but may be the cause
of the problem can not be determined at all. In this case, they are displayed system messages and
their error codes. Messages and error codes can be read by the Windows system administrator.
You can try the following:
•
Make sure Bluetooth is turned on the recorder and try again.
•
If a recording being performed, press and and hold the event button for approx. 3
seconds, until a series of beeps indicates that the wireless connection is enabled.
•
Disconnect on your Microsoft Windows device any embedded Bluetooth module. Details can
be found in the "
A module already installed, for wireless data transmission, must be turned
be found in the "
A module already installed, for wireless data transmission, must be turned
Reset iOS App
ATTENTION
To reset the recorder, all data will be erased from the recorder and the protection code is
reset.
You can reset the recorder as follows:
1.
Turn on the recorder.
2.
Start the application.
