47
Programming the Gyro
The gyro is programmed with the SET button and the tail control lever of the transmitter. Do not leave too long of a break
between the individual programming steps; otherwise, the gyro will react incorrectly. In this case, switch off the gyro’s
power supply and take it into operation again after a few seconds.
• For this, take the gyro into operation in AVCS mode so that the
LED S lights up green.
• Keep the Set button pressed for approx. 3 seconds with a small
screwdriver.
• Release the SET button when LED 1 is lit.
• LED S changes colour from green to orange to indicate
programming mode
Servo Type Selection
• Use the tail control lever to switch the light colour of LED 1 and
to thus select the required servo type.
Green = digital servo
Red = analogue servo
Changing the Rotating Direction of the Tail Servo
• Press button SET again.
• LED 1 goes out and LED 2 lights up.
• Use the tail control lever to switch the light colour of LED 2 and
to thus select the servo direction.
Green = normal direction
Red = reverse direction
S
1
2
3
SET
3 sec.
Figure 7
S
1
2
3
SET
Figure 8
S
1
2
3
SET
Figure 9
