Galvanic Applied Sciences 943-TGX-CE, Руководство по эксплуатации

Страница: 66 / 151

Revision 4 66 April 2020
scale. The X ranges are time, affecting the amount of time represented by the displayed
trend lines. The maximum time range that can be displayed on the trend graphs on both
panels is fifteen minutes.
Changing the displayed scale on the Analysis 1 / Analysis 2 trend graphs does
NOT change the scale on the analog outputs for these parameters. These
scales are for display purposes ONLY and have no effect on any other aspect
of the analyzer operation.
To edit any of these parameters, simply highlight the field for the parameter to be edited
using the F3 / F4 keys, then use the numerical keys and decimal point key to enter the
desired value and press
↵
again. Alternatively, the up or down arrows beside the data
entry field can be highlighted using the F3 / F4 keys, and then the
↵
key can be
continuously pressed until the desired value is obtained.
4.8.3.2 Backlight Adjustment
The intensity of the analyzer display’s backlight can be adjusted on this sub-panel. Simply
use the F4 / F3 keys to highlight either the
More (brighter) or Less (dimmer) buttons, then
press the
↵
Key continually until the display brightness is adjusted the desired level. When
the slider is at the left-most position, the display backlight is completely off, and when at
the right-most position the backlight is turned on to 100% power.
Once all desired changes have been made on the Display sub-panel, use the F4 / F3
keys to highlight the Save button, then press
↵
to save all changes permanently to the
analyzer. Alternatively, select the Revert button and press
↵
to revert all changes made
since the last time the Save button was pressed.
4.8.4 Timers/Alarms Sub-Panel
The Timers/Alarms sub-panel shown in Figure 40 is used to configure a variety of
parameters related to timers, temperature control, and alarm setpoints.
Figure 40: Timers / Alarms Sub-Panel