Galvanic Applied Sciences 943-TGX-CE, Руководство по эксплуатации

Страница: 117 / 151

Revision 4 117 April 2020
Figure 74: UV Lamp Orientation
DO NOT touch the front face (light emitting side) of the lamp. Dirt, grease,
and human skin oils can affect the lamp spectral performance. Always
handle the lamp by the metal base.
DO NOT apply power to the lamp with the cover removed. Intense UV
radiation can cause severe eye damage.
11. Replace the two lamp retaining screws (5-40 x 3/8") and tighten using a 3/32" ball
driver passed though the holes on the top of the lamp enclosure.
12. Replace the two plastic plugs on the top of the lamp enclosure.
13. Reconnect the three wires from the lamp to the terminal strip. The wires are colour
coded
on the terminal strip. Connect the lamp’s blue wire to the blue terminal, the red
wire to the red terminal, and the black wire to the black terminal. If the lamp has two
black wires instead of a blue and a black, connect one of the black wires to the blue
terminal and the other to the black terminal.
14. Reinstall the UV lamp enclosure cover. Tighten the cover cap screws.
15. Reconnect the AC terminal block fuse terminal on terminal block ACTS:28 by pressing
down and snapping it into place. Place the UV Lamp power switch to the ON position.
16. Close and latch the control cabinet door.
17. Ensure that the analyzer is still in backpurge mode.
18. Using the keypad, navigate to the Spectrum panel.
33. Optimize the integration period by using the F4 / F3 keys to highlight Optimize Integ.
Time , then press
↵
.
34. Observe the optimized integration time. If the High Integration Period warning has
cleared, no further work is required at this time. Proceed to the next step in this
This side faces
towards
the
anti-solarant
fluid holder.