Furuno FSV-75, Руководство оператора

Страница: 225 / 235

APPENDIX 2 ERROR CODE LIST
AP-9
133 Resolver Signal Mal-
function Error occurred in resolver
signal. There is a problem in the po-
sition sensor inside the
transducer.
• Conduct the control box
test (see section 10.10.4)
and check that the RE-
SOLVER DRIVER STA-
TUS item is not shown as
“NG”.
• Reset the system power.
134 Resolver Signal DC
(COS side) Resolver Signal side COS
disconnect. There is a problem in the po-
sition sensor inside the trans-
ducer.
• Conduct the control box
test (see section 10.10.4)
and check that the RE-
SOLVER DRIVER STA-
TUS item is not shown as
“NG”.
• Reset the system power.
135 Resolver Signal DC
(SIN side) Resolver Signal side SIN
disconnect.
136 Resolver R/D Converter
Fault Resolver R/D Converter is
fault.
137 Resolver Internal TEMP
Fault Resolver internal tempera-
ture is fault.
138 Motor Step-out Motor Step-out occurred. A step-out was detected in
the hull unit motor.
• Conduct the control box
test (see section 10.10.4)
and check that the MO-
TOR SELF TEST item is
not shown as “NG”.
• Reset the system power.
139 Motor Sensor Calibra-
tion Data Error Motor Sensor Calibration
Data Error There is a problem in the mo-
tion sensor. Reset the sys-
tem power.
Transceiver Unit
200 B Voltage Fault B voltage is over normal
range. An abnormal voltage was de-
tected.
• Conduct the operation test
(see section 10.10.2) and
check the voltage for the
+B item in the PWR sec-
tion of the test results.
• Reset the system power.
201 Transceiver Fan Error Fan RPM has lowered. Fan RPM is abnormally low.
• Conduct the FAN monitor
test (see section 10.10.5)
and check that the value
for each fan is not red. If
any fan’s RPM is shown in
red color, consult your lo-
cal dealer for service.
• Reset the system power.
205 Motion Sensor Malfunc-
tion Motion sensor status fail. There is an error in the mo-
tion sensor. Reset the sys-
tem power.
Error
Code
Error Message
Description (as appears
in error list)
Meaning and Remedy