Fujikura KSP75-FP-005468, Инструкция по эксплуатации

Страница: 56 / 77

52
Management Menu
2. Power Save
This function is important for battery conservation. If the power saving function is not
set during battery pack use, the number of splice cycles will be reduced. The splicer
automatically identifies the type of power supply unit and can be programmed to utilize
difference power save settings for different power supplies.
Setting Power Save
(1) Insert a power unit and turn splicer
power on.
(2) Select [Power Save] in the
[Management Menu]. [Power Save] is
displayed for the type of power
supply used.
(3) Change value of [Monitor Shut
Down] and [Splicer Shut Down].
Parameter Descriptions
Power Source Type The type of power supply.
Monitor Shut Down
Setting this function turns off the power supply to the LCD
monitor if the splicer does not perform an action within a
certain period of time. Always set this function to a
specific shutdown time when using the battery pack.
When the power supply to the
LCD monitor turns off, F mark is
displayed at intervals of 5 seconds
on the monitor. Pressing any key
turns on the LCD monitor.
Splicer Shut Down
Automatically turns off the power supply to the splicer if it
performs does not perform an action within a certain period
of time. The function serves to prevent the battery capacity
from running low if the splicer is left on for an extended
period of time.
• The value can be changed only
for the power unit being used.
Power Save Menu
Select the [Power Save] in
the [Management Menu]