FujiFilm SONOSITE X-PORTE, Руководство пользователя

Страница: 228 / 366

8-10 Cleaning and disinfecting
a Use either a pre-moistened wipe or a soft cloth dampened with cleaner or disinfectant. Choose a cleaner
from the list of approved cleaners.
b Remove all gel, debris, and bodily fluids from the transducer.
c With a new wipe, clean the cable and transducer, starting from the cable, wiping toward the scanhead.
This method helps to avoid cross-contamination.
d Observe the required wet contact time and refer to manufacturer’s instructions. Monitor the transducer for
wet appearance. Re-apply with a new wipe if no longer wet.
8 Verify that all gel, debris, and bodily fluids have been removed from the system and transducer. If
necessary, repeat steps 5, 6, and 7 with a new wipe.
Approved cleaners/disinfectants for the transducer:
Product Compatible transducers
Minimum wet contact time
a
SaniCloth AF3
b C11xp, C35xp, C60xp, HFL38xp,
HFL50xp, HSL25xp, ICTxp, L25xp,
L38xp, P10xp, P21xp, rP19xp 3 minutes
SaniCloth Plus C60xp, HFL38xp, HFL50xp, ICTxp 3 minutes
PI-Spray II C11xp, C60xp, D2xp, HFL38xp,
HFL50xp, HSL25xp, ICTxp, L25xp,
L38xp, P10xp, P21xp, rP19xp 10 minutes
a
For maximum effectiveness, the component being cleaned must remain wet with disinfectant for a minimum
period of time.
b
Qualified for use as an intermediate-level disinfectant for mycobacteria.
Refer to the cleaners and disinfection document available at www.sonosite.com for a complete list of the most
current cleaners and disinfectants.
Caution Do not allow moisture near the electronic components of the connector.