Fuji Electric LONWORKS OPC-LNW, Инструкция по эксплуатации

Страница: 77 / 84

35
ENGLISH
(3) SCPT_minSendTime
Minimum pause period for send. This CP specifies the send prohibit time length for all output NVs listed in
Table 7-13 in block. Until this time has elapsed, the interface card does not output any NVs even if the NV
value changes within this time length.
Setting this CP at 0.0 s provides no send prohibit time length.
- Data setting range: 0.0 to 6553.4 s (0.1 s resolution)
- Default setting: 0.0 s (Inactive)
Table 7-13 NVs with Minimum Pause Period Specified by SCPT_minSendTime
Index NV name
All output NVs except the following
nv33 nvoReadParamVal
nv34 nvoAccessErrCode
(4) SCPT_minDeltaLevel
Minimum data change rate for send. This CP specifies the hysteresis width or minimum insensitivity band
on data change for individual NVs listed in Table 7-14. If a data change exceeding the band occurs in an NV,
the NV can fetch the change in its data and the interface card outputs it.
Specify the band in the ratio (%) to the 100% value of each NV value. Table 7-14 lists the 100% value of
each NV.
Setting 0.0% also inactivates this CP.
- Data setting range: 0.0 to 200.0% (0.5% resolution)
- Default setting: 0.0% (Inactive)
Table 7-14 NVs with Minimum Data Change Rate Specified by SCPT_maxSendTime
Index NV name Unit 100% value
nv3 nvoDrvCurnt A Rated output current of the inverter
nv4 nvoDrvSpeed % 100%
nv5 nvoDrvVolt V Base voltage. Same as data of inverter's function code
F05.
When F05 = 0 (not AVR-controller), 200/400 VAC.
nv6 nvoDrvPwr kW Capacity of the inverter
nv24 nvoOutputFreq Hz Value specified by SCPT_nomFreq
nv25 nvoDrvTorque % 100%
nv30 nvoDCbusCapacity % 100%
nv31 nvoDrvTemp_1 °C 100°C
nv32 nvoDrvTemp_2 °C 100°C
nv35 nvoAIVal_1 % 100%
nv36 nvoAIVal_2 % 100%
nv37 nvoAIVal_3 % 100%
nv38 nvoPIDFb % 100%