SAFETY THERMOSTAT WITH RESET
REMOVAL AND REPLACEMENT OF PARTS
Page 31
Service Manual TDR8 P Gas form 9124023 rev. 01/2022
RELAY
1. Remove the right side panel according
prior procedure.
2. Loosen the clamp handle.
3. Gently remove the relay.
4. Reverse the procedure to install.
Note:
When placing a relay be sure the con-
necting pins are in place.
Remark:
The thermostat with manual reset is
only used for the following 6 serial numbers.
100064637 and 638 + 100064776 until 779.
all other units have a thermostat with auto-
matic reset.
1. Remove the rotor and the right side panel
according prior procedure.
2. Remove the bolts that secure the air
guide plate and remove this plate. Lower
the plate in vertical position and lift it out
of the hinge pins.
3. Remove the thermostat-probe from the
clip in the oven and guide it outside
through the opening in the side wall.
4. Disconnect the wiring on the thermostat.
5. Remove the screws on the electric panel
that secure the thermostat and remove
the thermostat.
6. Reverse the procedure to install.
Note:
Set the new thermostat to its maxi-
mum position by turning it clockwise (320°C).
Thermostat with
automatic reset
Thermostat with
manual reset
