PARAMETERS
Page 56
Service Manual TDR8 P Gas form 9124023 rev. 01/2022
To store recipe programs from the CPU board to the memory stick is done as follows:
1. Place the memory stick and go to the Service menu (pincode 4878) choose “USB” and
confirm with “OK”.
2. Go to “store” and confirm with “OK”.
3. Choose “recipies”and confirm with “OK”.
4. Now choose a file name and confirm with “OK”.
5. Go to “save file” and confirm with “OK”.
Now the program will be written on the memory stick.
Notes:
• When the message “files not found” is indicated on the display try to reset the machine
by pulling the plug out for 5 seconds.
• The name of a file may not exist of more than 8 characters and can’t have a space be-
tween the characters. Check this in the program file on the memory stick.
• It is not allowed to have a open line in the recipie list. Remove the open line and try
again.
• If the reset doesn’t work try to load the software again.
• All recipe names must have the extension .csv.
READ AND STORE RECIPIES AND PARAMETERS IN THE SERVICE MENU
Recipies can be read and stored from both the Manager menu and the Service menu.
Recipies can only be read to, or stored from the CPU board by means of a memory stick. The
transfer is always done out of a folder called “Programs”. This folder has to be placed direct
on the memory stick and cannot be placed in another folder, otherwise it will not work.
The folder can contain several files with programs. The name of a program file may exist of
maximum 8 characters and can’t have a space between the characters, otherwise it will not
be read or stored.
When reading a new program to the CPU board the old program will be deleted. So it’s
adviseable to store the old program first on your memory stick.
How to read and store
recepes see also USB on page 24.
To read a recipe program from a memory stick to the CPU board is done as follows:
1. Place the memory stick and go to the Service menu (pincode 4878), choose “USB” and
confirm with OK.
2. Go to “read” and confirm with “OK”.
3. Choose “recipies”and confirm with “OK”.
4. Go to “read stick” and confirm with “OK”.
5. Choose file name, with “other file”, and confirm with “OK”.
6. Now go to “read file” and confirm with “OK”.
Now the new program will be loaded inside the CPU board.
