REMOVAL AND REPLACEMENT OF PARTS
Page 37
Service Manual TDR8 P Gas form 9124023 rev. 01/2022
1. Lift the inside door upward out of the
hinges and place it on a table.
2. Remove the nuts and rings on the pro-
files of the door.
3. Remove the profiles from the glass.
4. Mount the profiles on the new glass.
Do not forget the Teflon flange bushes
inside the holes.
5. Mount the nuts and rings.
6. Place the door in the hinges.
Note:
Tightening of nuts max. 8 Nm.
DOOR GLASS INSIDE
DOOR OUTSIDE
1. Lift the inner door out of the hinges and
lay this aside.
2. Remove the left side panel according prior
procedure.
3. Remove the 2 nuts behind the upper hinge
and loosen the locknut according prior
procedure. The door must be closed.
4. Hold the door on both sides and move
this towards yourself, before lifting it out
of the hinge on the bottom side. See to it
that the washers stay on the hinge.
Also remove the top hinge.
5. Place the top hinge on the new door.
6. Place the new door on the hinge on the
bottom side and push the 2 studs on the
top hinge through the openings on the
top side and screw the nuts on it .
7. Adjust the door according prior procedure.
Note:
Tightening of nuts max. 8 Nm. or
5.9 lbf.ft
