
STG7
STG5
Page 23
Service Manual STG5/7 intelligent STW5/7 intelligent form 9123999 rev. 05/2010
REMOVAL AND REPLACEMENT OF PARTS STG
Remove the rotor discs, right side panel,
1.
suction and fan plate according to prior
procedures.
Disconnect the wiring from the element.
2.
Remove the mounting nut.
3.
Remove the element from the mounting
4.
clip and pull it from the wall.
Reverse the procedure to install.
5.
hEATING ELEMENT
Lift the inner door out of the hinges and
1.
lay the door aside.
Remove the left side panel according
2.
prior procedure.
Remove the 2 nuts behind the top hinge.
3.
The door must be closed.
Hold the door on both sides and move
4.
this towards yourself, before lifting it out
of the hinges. Place the door with the
rounded side down on a table.
Remove the screws, cap nuts and rings on
5.
the profiles of the door and remove the
profiles.
Mount the profiles on the new glass. Do
6.
not forget the teflon rings of 3 mm inside
the holes.
Reverse the procedure to install.
7.
DOOR GLASS OUTSIDE