Fresenius Vial INJECTOMAT 2000 Anasthesie, Техническое руководство

Страница: 18 / 82

Page : 14 NT 0928 Rev.A0
2.1.2. Description of connectors
2.1.2.1. J1 mains connector
Pin description
1 Neutral
2 Phase
2.1.2.2. J2 board / CPU connection
Pin Description
1 + 5V controlled power supply
2 GND power supply
3 + VBAT power supply
4 GND power supply
5 phase A motor control
6 phase B motor control
7 phase C motor control
8 phase D motor control
9 I signal motor control
10 BOOST signal booster command
11 sopt1 opto rotation module out put
12 sopt2 opto anti-siphon module out put
13 not in use
14 cdopt1 opto rotation control module
15 cdopt2 opto anti-siphon module control
16 OFF signal off key pressed ON/OFF
17 SECT mains power on signal power supply
18 CDALIM power cut signal
19 LDSECT mains LED control
20 CTS clear to send
21 DEB/OFF disengage signal active, set to 0
22 RTS request to send
23 OCC/OFF occlusion signal active, set to 0
24 BUZ nurse call relay control
25 EOC end of conversion ADC
26 CSADC selection bus SPI ADC
27 CLK clock bus SPI ADC
28 SI data IN bus SPI ADC
29 SO data out bus SPI ADC
30 CDANA analog sensor power control
31 RX2 receive data TTL line 2
32 TX2 transmit data TTL line 2
33 TXD1 transmit data TTL line 1
34 RXD1 receive data TTL line 1
35 TOFF OFF key
36 TON ON key
37 + VBAT power supply
38 GND power supply
39 + 5V power supply
40 GND power supply