Fresenius Medical Care 5008, Руководство по эксплуатации

Страница: 204 / 328

Chapter 10: Other Functions
10-28 Fresenius Medical Care 5008 OP 5/09.06
Touch the Filter change button.
Message: Filter change, Filter 1, Filter 2, Both filters
Select the desired filter(s).
Touch the
Start button.
Message: Filter change in progress.....
Message: Emptying of filter completed. Please confirm filter change!
Change the filter.
(e.g. filter 1)
Open the door of the dialysate filter chamber (1). Open the locking
levers (2). Slide the used filter (3) upwards and out of the guide slot.
Remove the protective straps from the new filter. Slide the new filter (4)
from the top into the guide slot. Close the locking levers (5). Close the
door of the dialysate filter chamber (6).
Touch the Confirm button.
Message: Filter change in progress.....
After the filter(s) has/have been primed:
Message:
Disinfection required.
Touch the Cleaning menu button.
10.6 Cleaning the Dialysate Particle Filter
Turn the particle filter holder to the left (1). Pull it out slightly towards you
and turn it to the right (2). Clean the dialysate particle filter. Re-insert the
filter holder and turn it to the left, then push it lightly in and turn it again
to the right. In this last position the filter holder must click into place.
10.7 Collecting a Sample
Connect a syringe (1) (e.g. 10 10 ml Luer-lock) to the Luer-lock of the
sampling valve. Press the key (2) and keep it pressed. Lock the key with
the locking pin (3). Draw up the syringe (4) (discard the first specimen).
Release the locking pin (5). The key will automatically close the valve.
10.8 Removing Lines During Preparation
During Preparation, it is possible to remove the desired blood line part
via the
BLOOD SYSTEM MENU.
Caution
Disinfect the system after each filter change.