Operation and Maintenance Manual
OnyX Pride Recuperators February 2019
Frapol Sp. z o.o. reserves the right to introduce changes without any prior notice.
Page
35
To change the program, disconnect power supply to the controller. Insert the memory card into the indicated slot.
The new software should be stored on the memory card in *.pfc format and in the form of two files: a file with a
panel program and a file with a program for module A of the controller. Insert the new software directly into the
memory card without nesting the data in a subdirectory. When the card is entered into the panel, the update screen
starts. First of all, change the program in module A of the controller. After restarting the controller, go to
Menu
→
General
Settings
→
Software
update
and
then select
Update
panel.
CAUTION!
Power
supply
must
not
be
disconnected,
during
installation.
Otherwise,
the
controller
can
be
damaged.
CAUTION!
When
software
is
updated,
it
will
restore
factory
settings
in
the
controller.
Before
starting
the
recuperator,
it
is
necessary
to
reconfigure
the
settings
for
its
components.
•
Setting
the
address
- it assigns an individual address to a room panel in a given bus, if more than one room panel is
connected to the controller.
CAUTION!
To
ensure
that
the
system
operates
correctly,
assign
a
different
address
for
each
of
the
separate
room
panels,
choosing
from
the
100-132
pool.
•
Parental
control
- if this function is active, the menu cannot be accessed. Touch the screen for approx. 3 seconds to
unlock (you will see an animation showing the opening of a padlock).
•
Name
of
ecoSTER
TOUCH
– enter the same name as the one given by the user to the ecoSTER TOUCH room panel.
The assigned name should be identical for all the connected room panels.
•
ecoNET
Settings
- configuration of the WiFi network connection, if the ecoNET300-V Internet module is connected
to the controller. Connect the ecoNET300-V module to the controller, as described in section 5.6.9, enter SSID –
network identifier, select the type of Wi-Fi protection, and enter password for the selected Wi-Fi network. Further
configuration of the module must be carried out, according to the Operation and Maintenance Manual for
ecoNET300-V.
•
Screen
saver
settings
-
Setting the
Screen
saver
On/Off
parameter to YES makes the screen go dim or off, after a
certain period of time. The period time to start the screen saver is set in
Time
to
activate
screen
saver.
To set the
backlight value during the active screen saving mode, go to
Backlit
screen
saver
.
8.14
Working
with
the
Internet
module.
Ordering
a
control
system
equipped
with
an
ecoNET
module,
which
provides
access
to
the
services
available
in
the
ecoNet
System
–
the
Administrator
of
which
is
PLUM
Sp.
z
o.o.
in
Ignatki,
is
tantamount
to
accepting
the
Terms
and
Conditions
of
the
website
and
the
EcoNET
service
available
at
http://www.plum.pl/index.php/econet#pobierz
,
as
well
as
by
email,
at
every
request
of
the
User.
At
the
same
