Operation and Maintenance Manual
OnyX Pride Recuperators February 2019
Frapol Sp. z o.o. reserves the right to introduce changes without any prior notice.
Page
12
4.
Transport
and
storage.
The device should be stored in its original packaging, in a dry place, not exposed to weather conditions, in which the
temperature remains between -25°C and +50°C.
The recuperator can be transported by means of a forklift or a crane, in its normal operating position, paying special
attention to protecting the side surfaces and protruding elements against damage. Make sure that the inspection flaps are
closed, before lifting the unit.
5.
Installation.
5.1
Place
of
assembly.
The OnyX recuperator must be installed in a utility room, a boiler room, a garage, or in a room specifically adapted for this
purpose. For safety reasons and due to the nature of the device, the recuperatormust not be operated at an ambient
temperature below 5°C. The building in which the device is to be installed must be seasoned, and all plasters, paints, and
floors must not be damp. Do not install the device indoors, where there is a high level of dustiness (gypsum finish residues
or residues after scraping floors).
Before installing the appliance, a visual inspection of the general condition of the appliance must be carried out, checking
also the conformity of all the components with the list of sub-assemblies.
The recuperator must be mounted on a suitable platform, a wall or a ceiling, or on a metal structure that ensures the correct
load-carrying capacity, space and uniform support for the recuperator. Since it is required to provide drainage of
condensate, the device should be set up in such a way that a water trap can be fitted. Provide a free space on the operating
side of such width that allows opening all inspection flaps and carrying out normal operations. Hydraulic systems, electrical
systems, etc., must be located in such a way that they do not hinder access to the recuperator.
CAUTION!
Before
installing
the
device,
it
is
necessary
to
select
appropriate
fastening
elements,
taking
into
account
current
provisions
of
the
building
law.
Carry
out
appropriate
calculations,
taking
into
account
parameters
of
the
substrate
on
which
the
control
panel
is
to
be
mounted.
5.2
Assembly
sequence.
•
Remove packaging,
•
place the recuperator on the structure, in accordance with the guidelines specified in item 5.1.
