Franklin Fueling Systems TS-SCM, Руководство по установке

Страница: 31 / 40

27
APPLICATION EVENT REPORTS
Application Event Reports include any system warning pertaining to TS-SCM equipment that occurred
within the date range chosen by the user.
ALARMS
When a console is in alarm, the Alarm LED on the front of the console will flash. If TS-SCM has been
programmed to shut down the pump on alarm (in the TS-SCM Setup), the pump will be unavailable for all
system tests and dispensing until the containment with the active alarm is manually Reset. If the condition
still exists after reset, the alarm will return. A service visit may be required to identify and correct the
condition.
WARNING
: Always REMOVE POWER from the console prior to installing/removing a module or
performing any maintenance while the console door is open.
NOTE : Refer to the Important Safety Messages outlined in the beginning of this manual before performing
any console maintenance.
NOTE : If at any time while troubleshooting a Warning or Alarm this guide is not able to help you correct
the issue, please contact FFS Technical Services.
SCM ALARMS AND WARNINGS
To troubleshoot your alarm or warning, identify the Alarm/Warning display on the console in the table
below and review the solution presented in the Error Code Table that follows.
Alarm/Warning Possible Error Codes
Channel Not Learned G
Failed to Hold Vacuum A, B, H
Failed to Reach Target Vacuum A, B, C, D, F
Low Vacuum A, B, C, D, F
Low Vacuum and Pump Request Ignored A, B, F, G
Not Configured G
Not Learned G
Program Error Detected Check TS-SCM Programming
Pump Request Ignored F
Unstable Vacuum B, D, C
Vacuum Sensor Failure E
Vacuum Sensor Failure / Not Connected E
Vacuum Too High B, G