51
Note:
(1) Please do not proceed with joystick correction when voltage is low. When voltage is low, please rotate
power key switch to OFF position and replace battery.
(2) Joystick correction has to be proceeded by following joystick axis sequence, otherwise joystick correction
cannot be continued and status LED display will also show as orange fast blinking light. If transmitter is
available with both digital and proportional joysticks, please correct the joysticks by following correction
steps for digital and proportional joystick respectively.
(3) Under “Correction Standby” condition, if no joystick is operated for more than 30 seconds, buzzer for
joystick correction overtime will have one long beep for warning. Status LED display will also show as red
LED ON_0.1sec/OFF_0.3sec with 5 blinks and OFF_0.8sec, then correction will be discontinued. There is
no sequence request for joystick correction. After long as correction for all joysticks is completed, the
status LED will continue to blink slowly in orange.
(4) Under “Correction” condition, if the joystick axis is not changed for more than 30 seconds or if the joystick
is back to neutral position, buzzer for joystick correction overtime will have one long beep for warning.
Status LED display will also show as red LED ON_0.1sec/OFF_0.3sec with 5 blinks and OFF_0.8sec, then
correction will be discontinued. During joystick correction, if status LED blinks in red for 5 times (please
refer to “Encoder status LED display”) and there will have long beep on the buzzer, then the correction is
failed. In this case, please shutoff the power and start the correction again.
(5) Under “2
nd
step Correction” condition, only the maximum joystick axis value will be recorded. No timing
will be over 30 seconds. During the 2nd step correction, please operate the joystick forward smoothly. Do
not shake the joystick or operate the joystick backward, otherwise the joystick correction cannot be
completed. Under “Correction Mode condition”, the power status LED displays in orange and the
correction has to be completed in 3 minutes. If not, the status LED blinks in red for 5 times (please refer to
“Encoder status LED display”) and there will have long beep on the buzzer, then the correction is failed. In
this case, please shutoff the power and start the correction again.
(6) Under “Correction Standby” condition, if the joystick axis buzzer has three beeps, that means the joystick
has been operated forward over half way. Please keep on operating the joystick forward to the axis end for
correction.
7.3.5 Function Change Settings
1. One end of the Alpha 6000 USB programming cable connects to computer, the other end connects to encoder
board inside transmitter as shown below. (Remove the Power Key first)