30
double speed interlock pushbuttons are all released. The transmitter buzzer and error status light
will be ON continuously to warn the operator. To release the inhibited joystick and pushbuttons
function by the error status light:
1. To release “Inhibit the joystick and pushbutton function“, press START button when the joystick
position is neutral (unrelated to VR) and pushbutton is released. The transmitter buzzer and error
status light will be OFF then back to normal operation.
2. After the emergency stop button is elevated, start the system again by following the “Transmitter boot
condition”.
Note: Transmitter drop and tilt protection are sharing the same method.
* Transmitter transmission intermittently
◎
Not enable: Transmitter sends signal 10 times every second.
◎
Enable: Transmitter sends signal 4 times every second.
* Transmitter battery replacement, auto-recovery
◎
Not enable:
◎
Enable: The batteries can be replaced during transmitter operation. (without pressing EMS button or
turning off the power) After the batteries are replaced, the transmitter can be operated
normally.
Transmitter START button startup
and
EMS button press/release check will be
omitted.
Remark: This function is only for the transmitter. When the battery is removed from the transmitter, there will be no signal on the
receiver and MAIN relay will be deactivated.
A.
If “receiver MAIN activate term: ID matches” is selected: Signal will be sent as soon as transmitter battery is inserted.
When ID matches and receiver receives signal from the transmitter, MAIN relay will be activated.
B.
If “receiver MAIN activate term: START button” is selected: Signal will be sent as soon as transmitter battery is
inserted. When ID matches and receiver receives signal from the transmitter, MAIN relay will not be activated until
START button is pressed.
* Transmitter power ON, emergency stop button press/release check
◎
Not enable:
◎
Enable: After the transmitter power key is rotated to ON position and before the emergency stop
button is pressed, the LED status: green LED blinks ON_0.1sec, OFF_0.9sec. Press and
release emergency stop button, then transmitter will be started. This is to ensure the
emergency stop button function without problem before transmitter operation.
4.3.2.2 Receiver Function Settings
* Receiver MAIN relay activate condition
◎
ID match: Transmitter and receiver ID is identical
◎
START button: Make sure transmitter and receiver ID is identical, then press START button on the
transmitter.
* Receiver MAIN relay dynamic check
◎
Not enable:
◎
Enable: Before MAIN relay is ON, first proceed with dynamic check. If pass, then MAIN relay is
