46
(Fig. 17) Receiver Installation
6.3 Preparation
1. Required Tools:
(1) Flat Head Screwdriver (-)
(6) Self Drill φ10.5 mm ~φ11 mm
(2) 5 mm Wrench
(7) Needle-nose pliers
(3) Multi-Meters
(8) Diagonal pliers
(4) 14 mm Box Wrench or Socket Wrench
(9) Wiring Cable(cord between 14 mm ~18 mm) and
Materials
(5) Power Drill with 10.5~11mm Drill-Bit
2. Ensure receiver is not set to the same frequency channel and ID code as any other units in
use at the same facility or within distance of 300 meters.
3. Prior to installation, make sure that the crane system itself is working properly.
4. Use the multi-meter to check the voltage source available and ensure receiver voltage
setting is correct for this voltage.
5.
Prior to installation, switch off the main power source to the
equipment.
6.4 Steps-By-Steps Installation
1. Be sure to put a stopper in the cable gland not in use after
wiring is completed.
2. Select a suitable location that is far from high voltage wiring or
equipment, such as motor, relay…etc., to mount the receiver.
3.
As much as possible, the location selected should have the
antenna visible from all areas where the transmitter is to be
used.
4.
The location selected should not be exposed to high levels
of electrical noise.
5. Ensure the selected location has adequate space to accommodate the receiver enclosure.
6. The distance between the antenna and the control panel should be as far apart as possible.
7. The use of an external axial cable to move the receiving antenna to the position for better signal
receipt where it is necessary.
8. Drill four holes on the control panel (11mm).
9. Tightened all screws provided.
10.
For system wiring, please refer to the wiring diagram located on the last page of this manual and
on the backside of the receiver cover plate.
11.
Ensure all wiring is correct and safely secured and all screws are fastened.
12.
The power cable has to be connected to the AC position of power terminal block; the
ground wire has to be connected to the GND position (crane metal frame) or to the screw
fixing hole of ground wire on the receiver.
