34
available upon request) That is each DC voltage output module is available with 8pcs of DC voltage
relay output. Whenever two types of voltage output, including relay and DC voltage output, are
mix distributed, relay K1~K32 may be applied to exchange output position. Arranging relay output
to relay module and DC voltage output voltage to AC voltage output module.
For example: 14-relay output and 7 DC voltage output are needed.
If you apply relay K1~K32 output position to exchange functions, the 14 relays will be
arranged from K1 toK14. Each receiver relay module, including slot I and II, with one relay
module. Keep K15 & K16 empty and then arrange 7 DC voltage output from K17 to K23.
Insert DC voltage output module to receiver relay module slot III.
Case 2:
After the wiring for receiver relay output is completed, if more or less function is needed, relay
number and sequence will have to be changed and the re-wiring is needed. Relay K1~K32 output
can be applied to exchange function. For increasing relay numbers, the new wiring sequence can
be re-arranged manually to match the original wiring arrangement. Then move the increasing
relays to the last position in sequence, so that only the increased relay contacts need to be wired, the
original wiring will remain unchanged. For decreasing relay numbers, the new wiring sequence can
be re-arranged manually to match the original wiring arrangement. Then keep the decreasing relay
positions empty, so the original wiring will remain unchanged.
4.4 Special Types:
＊
“Pitch and Catch” Feature/Assigned button AUTOSCAN as below:
(1) Two transmitters (or more) take turn to control one receiver.
(2) Move the transmitter joystick and VR in operation back to neutral position and depress
assigned pushbutton for 0~3 seconds (by following “enter auto-scan channel delay time”).
(3) After the assigned pushbutton signal is received by the receiver, the receiver will look for
the transmitter which is going to take turn by AUTOSCAN.
(4) Press START button on the transmitter that catches the signal for 0~3 seconds (No assigned
pushbutton is pressed. Please follow “time for salve channel lock” setting).
(5) After the receiver has scanned and caught the transmitter that takes over, the AUTOSCAN
control will also be taken over by the transmitter that takes over.
(6) Please turn off the original transmitter in operation.
＊
One Transmitter to Two Receivers Feature (Tandem Mode):
two operation types
(1) Transmitter 1 operates receiver 1 or receiver 2 independently; transmitter 2 operates
receiver 1 or receiver 2 independently.
Alpha 6000
Receiver
Alpha 6000
Transmitter
Alpha 6000
Transmitter
