Foerster TAK5-CH1-25, Инструкция по эксплуатации

Страница: 68 / 226

68 Setup
4.8.3 Scales
Here you can configure the scales which are connected to the
automatic feeder. Up to twelve scales controls per feeder can be
connected and each control is able to control two animal scales.
Unit 1 and unit 2
In the line unit 1 select the feed or concentrate station to which
the first weighing unit of the scales control has been connected.
Same procedure for unit 2 , if necessary.
Address
The scales control is part of the CAN-bus system. Therefore,
each scales control requires an address for clear identification
purposes. This address is defined on the board of the scales
control via the DIP-switch ( Instruction manual of the half-
body scales ).
4.9 Terminal
Address
The hand-held terminal is part of the CAN-bus system of the
automatic feeder. Therefore it requires its own address. The
default address is 1.
stations
feed
concentrate
animal scales
<scales control 1>
unit 1: [F-st. 1]
unit 2: [C-st. 1]
address: 21
Note: Within a CAN-bus system an address can be allo-
cates only once. The default addresses are the following:
Scales control 1 = address 22
Scales control 2 = address 22
...
Scales control 8 = address 28
address
already allocated!
Note: If you select an address that has already been allo-
cated, the message on the right will be displayed.
setup
...
terminal
communication