Foerster TAK5-CH1-25, Инструкция по эксплуатации

Страница: 157 / 226

Diagnostic 157
•
compatibility problems between the program version of
the automatic feeder and the IFS arose ( ID ),
•
the same CAN-bus-addresses were allocated to the ma-
chines ( double address ),
•
a connection fault with the ID-chip occurred,
•
unknown transmitters were detected by the identification,
•
a message was given that an animal number has already
been allocated ( double animal no. ),
•
the circulation pump check was negative,
•
the detergent sensor signalled „empty“,
•
the motor shaft did not turn ( mot. sens. C-st. 1 ),
•
the sensor for empty signal did not signal „covered“ although
the unit for feed dispense had turned ( empty C-station 1 ),
1. > diagnostic > control
2. Select the failure that occurred.
3. In since you can view when the inputs were deleted last.
4. Confirm delete? with to delete the faults.
10.6 Version
In Version you can check the version numbers of the following
units:
•
the automatic feeder,
•
the procesor,
•
the ID-chip,
•
the terminal,
•
the identifications of all the available feeding and concen-
trate stations
<power failures>
amount: 2
since: 30.04.09
delete?
diagnostic
valves
motors
heating
sensors
stations
control
version
setup
software