Operating Manual CMGZ 622
51
Holding torque
Applies to:
Unwind brake
Use:
This parameter defines the holding torque that is active during
machine stopped. It has to be set in a way that the reel is hold during
stop, but no material breakage can appear during start up.
If parameter
Torque in use
is set to
No
the holding torque will be
output only when the controller is getting enabled.
If parameter
Torque in use
is set to
Yes
the holding torque is already
output even the controller is disabled.
„10“ means „10%Out“, that is 10% of 10V = 1.0V.
Range:
0.0
to
100.0
Default:
0.0
Increment:
0.1
Unit:
[%Out]
Taper function
Applies to:
Winding
drive
Use:
This parameter defines the shape of the characteristic curve for the
taper function (ref. to „12.4 Taper function“)
(To be developed – ask FMS customer service)
Range:
No, Linear, Square, Root
Default:
No
Reduction factor
Applies to:
Winding
drive
Use:
This parameter stores the reduction factor for the tension reduction.
It corresponds to the relation from reduced tension (at Dmax) to
normal tension (at Dmin) and is calculated using the following
formula:
(To be developed – ask FMS customer service)
Range:
0.000 to
1.000
Default:
0.000
Increment:
0.001
Unit:
[-]
reduced tension at Dmax [N]
Reduction factor =
normal tension at Dmin [N]
