Fluke 5790A, Руководство оператора

Страница: 35 / 220

Installation
Introduction
2
2-3
 Warning
To avoid electric shock and to conform to IEC Safety Class I,
use the 5790A only with sources up to 1000 V dc or rms ac that
are protected from short circuit with current-limiting to 200 mA
or less.
2-1. Introduction
This section provides instructions for installing the 5790A and connecting it to line power.
Because this section explains fusing and operating environment requirements, you should
read this section before operating the instrument. Instructions for connecting cables to other
standards and to a UUT (Unit Under Test) during operation are in Section 4.
2-2. Unpacking and Inspection
The 5790A is shipped in a container that is specially designed to prevent damage during
shipping. Inspect the 5790A carefully for damage, and immediately report any damage to
the shipper. Instructions for inspection and claims are included in the shipping container.
When you unpack the 5790A, check for all the standard equipment listed in Table 2-1.
Also check for accessories if any were ordered. If performance tests are required for your
acceptance procedures, refer to Section 3 of the 5790A Service Manual for instructions.
Line power cords available from Fluke are listed in Table 2-2 and illustrated in Figure 2-1.
Table 2-1. Standard Equipment
Item Model or Part Number
AC Measurement Standard 5790A
Line Power Cord See Table 2-2 and Figure 2
Type "N" Extender (protects connector) 875443
5790A Operator Manual 893284
5790A Remote Programming Reference Guide 893375
5790A Service Manual 893292
Report of Calibration N/A
Table 2-2. Line Power Cord Types Available from Fluke
Type Voltage/Current Fluke Option Number
North America 120V/15A LC-1
North America 240V/15A LC-2
Universal Euro 220V/16A LC-3
United Kingdom 240V/13A LC-4
Switzerland 220V/10A LC-5
Australia 340V/10A LC-6
South Africa 240V/5A LC-7