Fluke 5790A, Руководство оператора

Страница: 119 / 220

Remote Commands
Alphabetical List of 5790A Device-Dependent Commands
6
6-13
Example
*STB?
Returns "72" if bits 3 (EAV) and 6 (MSS) are set (1) and the rest of the bits are reset (0).
*TRG
Triggers a measurement (equivalent to TRIG).
Parameter
None
*TST?
Initiates a series of self-tests, then returns a "0" for pass or a "1" for fail. Included are the
ROM checksum test, nonvolatile memory test.
Parameter
None
Response
(Integer) 0 = Pass, 1 = Fail
*WAI
Wait-to-continue command. This command prevents further remote commands from
being executed until all previous remote commands have been executed. (See also
*OPC.)
Parameter
None
Example
If you had sent a TRIG command, you can cause the 5790A to wait until the
measurement has settled before continuing on to the next command by following TRIG
with a *WAI command. This is useful because TRIG is an overlapped command, which
means the 5790A would normally go on to process other commands before completing
the TRIG command.
6-3. Alphabetical List of 5790A Device-Dependent Commands
ABORT
Aborts a measurement, calibration or diagnostic procedure, calibration step in progress,
or report being printed. This command holds off execution of subsequent commands until
it is complete. (See Example.)
Parameter
None