Fluke Biomedical medTester 5000C Operators, Руководство оператора

Страница: 20 / 292

medTester 5000C
Operators Manual
1-8
These modules are software enabled for use by the medTester’s firmware.
The firmware is held in EPROM (erasable programmable read-only memory).
When you purchase one or more of the modules described below, you receive
a 3.5-inch floppy diskette containing the software functions of the module.
To load the module software, attach the appropriate serial cable from a
communications port on your personal computer to a communications port
on the medTester.
Once this connection is made, you receive instructions for enabling the
module in the medTester 5000C’s EEPROM (electrically erasable
programmable read-only memory).
medTester 5000C Modules
medTester
5000C
Module Name
Functions Enabled medTester
Prerequisites for Use of
Module
Required for...
RS-232/Printer
• Use of COM1 and
COM2 serial ports.
•
Use of the parallel
printer port.
• None • Remote operation of the
medTester 5000C from a
personal computer or
compatible terminal device.
• Two-way communication
between the
medTester 5000C and a Fluke
Biomedical analyzer or tester.
• Input from an optional
keyboard, bar code scanning
gun.
• Printing test record output.
Memory—
100 Records
• Test record
storage. • RS-232/Printer Module • Storing of test records.
Memory—
Expanded •
Storage of
autosequence and
medCheck data.
•
RS-232/Printer Module.
• Memory—100 Records
Module.
•
Autosequence testing.
• Use of medCheck.
Waveform/
Extended Testing
• Five (5) additional
safety
autosequences.
• ECG performance
waveforms.
• ECG arrhythmias.
• Line monitor test.
•
Environmental test.
• RS-232/Printer Module.
• Memory—100 Records
Module.
• Adding more customized
safety autosequences.
• Outputting ECG waveforms to
patient monitors.
•
Outputting ECG arrhythmias to
patient monitors.
• Periodic measurements of line
voltage.
• Measuring ground potential
and resistance between a
common ground point and
multiple points in a room.