5.2 RECHARGING THE BATTERY
1)
Connect the battery extension cable
1
to the
plug of the battery charger
2
.
2) Plug the battery charger into a mains socket
and charge the battery as long as the red
LED on the battery charger
2
remains on.
3) When the green LED on the battery charger
2
lights up it means that it is fully charged.
4) Disconnect the plug of the battery charger
2
from the battery extension cable
1
.
5.3 FITTING AND REMOVING THE BRUSH
CAUTION
Only use the machine if the brushes or pad drivers, together with abrasive disk, are installed
properly.
Assembly procedure:
1) Lock the handle using the locking lever.
2) Grip the handle and, using it as a lever to lift
the front of the machine, rotate it (
A
)
backwards.
3) Insert (
B
) the brushes onto the appropriate
pins and press (
C
) all the way down.
To remove them, follow the procedure
indicated in point 3 in reverse.
NOTE:
Follow the same procedure to fit /
remove the pad driver.
CAUTION
REPLACE the brushes / abrasive discs before the length of the bristles or the thickness of the
abrasive discs become less than 1 cm.
Working with brushes that are excessively worn, or abrasive discs that are excessively thin,
may damage the machine and the floor.
Regularly check the wear on these parts before starting to use the machine.
