5 USING THE MACHINE
5.1 PREPARING THE MACHINE
DANGER
!
All maintenance work or the replacement of accessories must be carried out in areas with
adequate lighting and only after having disconnected the machine from the power supply by
unplugging the battery connector.
CAUTION
Before starting, put on non-slip shoes, gloves and any other personal protection equipment
indicated by the supplier of the detergent or required by the environment in which the machine
is to be used.
NOTE:
Carry out the checks described below before you start to use the machine (refer to the relative sections
for a detailed description of these procedures).
1) Fit the brush or pad driver (with abrasive pad) that is suitable for the surface and the work to be performed.
2) Fit the squeegee and make sure that it is securely fastened, connected to the suction hose and that the
blades are not excessively worn.
3) Fill the solution tank with a mixture of clean water and a suitable amount of non-foaming detergent (using the
graduated container provided).
4) Check the battery charge level and charge if necessary.
NOTE:
To avoid hazards, we recommend that you become familiar with the machine movements by
experimenting on a large surface that is free from obstacles.
To obtain the best results in terms of cleanliness and the service life of the appliance, you should follow a few
simple, but important procedures:
Identify the work area and remove all possible obstacles that may get in the way. If the surface is very large,
work in contiguous and parallel rectangular areas.
Choose a straight work trajectory and start working from the area furthest away to avoid going over areas
that have already been cleaned.
BLOCKING / UNLOCKING SQUEEGEE LIFTING
Lifting the squeegee off the floor from plate “1” activate the snap lock “2”which allows the squeegee to remain lifted
from the floor.
To bring the squeegee back to the floor, lift the latch “2” releasing it.