5.6 REPLACING THE SQUEEGEE BLADES
1) Remove the squeegee
A
from its support (see previous section).
2) Completely unscrew the rear knobs
1
and remove the pins
2
.
3) Remove the squeegee blade
4
-
6
clamping strips
3-7
.
4) Remove the rubber blades
4
-
6
from the body
5
of the squeegee by pulling from one end.
5) To replace the rubber blade, follow the same procedure in reverse starting from the rear blade
6
.
6) Fit the rectangular holes on the blades into the seats on the body
5
of the squeegee.
7) Replace the blades
4
-
6
and the clamping strips
3
-
7
8) Insert the pins
2
and fasten the whole unit using the knobs
1
.
CAUTION
The front rubber blade is different from the rear blade as it has notches through which water
can pass.
The clamping strips are identical.
5.7 FILLING AND EMPTYING THE SOLUTION TANK
NOTE:
The temperature of the water or the detergent added should never exceed 50°C.
Always empty the recovery tank every time you fill the solution tank.
CAUTION
Use only products suitable for the floor and for the dirt that has to be removed.
