Falcon R-Class | User Guide
75
Ingress Map
selection through the Map ID. The Ingress Map ID ranges
from
0
to
255
. An empty field indicates no map selection.
Egress Map
selection through the Map ID. The Egress Map ID ranges
from
0
to
511
. An empty field indicates no map selection.
QoS Ingress Port Policers
This section allows you to configure the
settings for all switch ports.
A policer can limit the bandwidth of received frames. It is in front of the ingress queue.
Web GUI: Configuration > QoS > Port Policing
Figure 4-48: QoS Ingress Port Policers
Table 4-45: QoS Ingress Port Policers Parameters
The port number for which the configuration below applies.
Enable
Controls whether the policer is enabled on this switch port.
Rate
Controls the rate for the policer. The default value is 500. This value is
restricted to
100
-1000000 when the
Unit
is
kbps
or
fps
, and it is restricted to
1-
3300
when the
Unit
is
Mbps
or
KFPS
.
Unit
Controls the unit of measure for the policer rate as
kbps
,
Mbps
,
fps
or
KFPS
.
The default value is
kbps
.
Flow Control
If flow control is enabled and the port is in flow control mode, then pause
frames are sent instead of discarding frames.
Содержание Falcon-RX/812/G/A
Страница 1: ...Falcon R Class User Guide Falcon RX Software version 8 0 20 www fibrolan com...
Страница 11: ...Falcon R Class User Guide 11 2 System Description 2 1 Block Diagram Figure 2 1 R Class functional block diagram...
Страница 86: ...Falcon R Class User Guide 86 Web GUI Configuration QoS DSCP Translation Figure 4 58 DSCP Translation...
Страница 221: ...Falcon R Class User Guide 221 Web GUI Configuration LLDP LLDP MED Figure 4 162 LLDP MED Configuration displays...
