Falcon R-Class | User Guide
199
The
>>
will use the last entry of the currently displayed entry as a basis for the next lookup. When
the end is reached the text "No more entries" is shown in the displayed table. Use the
<<
button to
start over.
Web GUI: Configuration > IPMC > VLAN Configuration
Figure 4-142: IGMP Snooping VLAN Configuration
Table 4-136: IGMP Snooping VLAN Configuration Parameters
VLAN ID
The VLAN ID of the entry.
Snooping Enabled
Enable the per-VLAN IGMP Snooping. Up to 32 VLANs can be selected
for IGMP Snooping.
Querier Election
Enable to join IGMP Querier election in the VLAN. A router sends IGMP
Query messages onto a particular link. This router is called the Querier.
Querier Address
Define the IPv4 address as source address used in IP header for IGMP
Querier election. When the Querier address is not set, system uses IPv4
management address of the IP interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first
available IPv4 management address. Otherwise, system uses a pre-
defined value. By default, this value will be 192.0.2.1.
Compatibility
Compatibility is maintained by hosts and routers taking appropriate
actions depending on the versions of IGMP operating on hosts and
routers within a network.
The allowed selection is
IGMP-Auto
,
Forced IGMPv1
,
Forced IGMPv2
,
Forced IGMPv3
, default compatibility value is
IGMP-Auto
.
PRI
Priority of Interface. It indicates the IGMP control frame priority level
generated by the system. These values can be used to prioritize different
classes of traffic. The allowed range is
0
(best effort) to
7
(highest),
default interface priority value is 0.
RV
Robustness Variable
. The Robustness Variable allows tuning for the
expected packet loss on a network. The allowed range is
1
to
255
,
default robustness variable value is 2.
QI
Query Interval
. The Query Interval is the interval between General
Queries sent by the Querier. The allowed range is
1
to
31744
seconds,
default query interval is 125 seconds.
QRI
Query Response Interval
. The Maximum Response Delay used to
calculate the Maximum Response Code inserted into the periodic
General Queries. The allowed range is
0
to
31744
in tenths of seconds,
default query response interval is 100 in tenths of seconds (10 seconds).
Содержание Falcon-RX/812/G/A
Страница 1: ...Falcon R Class User Guide Falcon RX Software version 8 0 20 www fibrolan com...
Страница 11: ...Falcon R Class User Guide 11 2 System Description 2 1 Block Diagram Figure 2 1 R Class functional block diagram...
Страница 86: ...Falcon R Class User Guide 86 Web GUI Configuration QoS DSCP Translation Figure 4 58 DSCP Translation...
Страница 221: ...Falcon R Class User Guide 221 Web GUI Configuration LLDP LLDP MED Figure 4 162 LLDP MED Configuration displays...
