Festo CPX-FB23, Электронное руководство

Страница: 116 / 122

A. Technical appendix
A−12
Festo P.BE−CPX−FB23−EN en 0308NH
Module parameters of analogue output
modules type CPX−2AA−U−I Function no. Default setting
Monitoring the CPX module
Short circuit/overload at actuator supply (SCA)
Monitoring parametrizing faults
4828 + m * 64
1)
Active
Active
Reaction after short circuit
Short circuit/overload at actuator supply (SCA)
Short circuit/overload at analogue output
4828 + m * 64 + 1
1)
Switch Vout on again
Leave voltage/current
switched on
Data format analogue outputs 4828 + m * 64 + 3
1)
VZ + 12 bit
right−justified
(type 03−compatible)
Monitoring channel x
1)
Channel−by−channel enable channel 0:
channel 1:
Monitoring value below rated range
(lower limit value)
Monitoring value above rated range
(upper limit value)
Short circuit/overload at output
Monitoring wire fracture/idling
Monitoring parametrizing faults
4828 + m * 64 + 6
1)
4828 + m * 64 + 7
1)
Active
Active
Active
Inactive
Active
Signal range channel x
1)
Channel−by−channel setting of the signal range
4828 + m * 64 + 8
1)
Use the setting of the
DIL switches
Lower limit value channel x
1)
Channel−by−channel setting channel 0:
channel 1: 4828 + m * 64 + 9/10
1)
4828 + m * 64 + 11/12
1)
0
0
Upper limit value channel x
1)
Channel−by−channel setting channel 0:
channel 1: 4828 + m * 64 + 13/14
1)
4828 + m * 64 + 15/16
1)
4095
4095
Force channel x
1)
Force mode outputs channel x
Force state outputs channel x
2)
Disabled
Reset signal
1)
m = module number (0...10; counting of the modules from left to right, beginning with 0)
x = channel number (0, 1)
2)
Access is made protocol−specific (see manual for handheld)
Tab.A/13: Parameters of the analogue output modules