FarmTek Growers Supply GrowSpan 500 Series, Инструкция по эксплуатации

Страница: 89 / 146

89
Revision date: 12.02.16
Black-out System Installation
STRING AND TENSION MONOFILAMENT WIRES
1. Starting in the middle of the header, and working
outward, string 112570 monofilament wire from
the
bottom wire tensioner brackets installed every
18" along one end wall header, to the 113694 wire
brackets in the exact locations along the opposite
end wall header. Wires will snap into the tabs of the
corresponding 113323 tube clips at EACH mid rafter
header. Use one AS1002 cable clamp to secure
monofilament to the
bottom loop of the 113694 wire
brackets as shown. Tension until taut, BUT DO NOT
OVER-TIGHTEN. See diagrams.
NOTE: If desired, for ease of black-out material
installation, from side wall to side wall, run two lines
of 110012 pull-twine per bay OVER all corner cables
and bottom monofilament wires. Temporarily tie off to the rafter legs. These can then be used as guides to pull the
black-out material through the bottom and top monofilament wires later.
2. Once pull-twine runs are in place (if used), string & tension all of the top monofiliment wires, from the tensioners
installed every 36" along one end wall header, to the top loop of the 113694 wire brackets in the exact locations
along the opposite end wall header. Top monofiliment wires will sit in the tabs of the corresponding 113323 tube
clips at EACH rafter. Tension until taut,
BUT DO NOT OVER-TIGHTEN. See diagrams.
DETAIL
A
DETAIL
A
DETAIL
B
DETAIL
C
DETAIL
B
DETAIL
C
MONOFILAMENT
BLACKOUT HEADER
SLIP-ON BRACKET
CABLE CLAMP
NOTE:
CABLE CLAMP SHOWN AWAY FROM THE HEADER
FOR CLARITY. CABLE CLAMP MUST BE AS CLOSE AS POSSIBLE
TO THE BRACKET AND HEADER AS POSSIBLE.
BLACKOUT HEADER
TUBE CLIP
MONOFILAMENT
WIRE TENSIONER
BRACKET
MONOFILAMENT
BLACKOUT
HEADER
112570
Monofilament
Wire