FarmTek Growers Supply GrowSpan 500 Series, Инструкция по эксплуатации

Страница: 66 / 146

66
Revision date: 12.02.16
INSTALL ROLL-UP PANELS
‡
Film: Single roll of 108655: Field cut length in half.
Complete these steps:
1. For film, locate the roll of 108655 film, roll it out and
fold it in half (lengthwise). Cut the film in half.
ATTENTION:
Before cutting, measure film to verify
correct amount. Film typically ships 2' longer
per
side
(e.g., 36' building: film panel is 38' long).
2. Stretch a panel along one side of shelter and center
it end-to-end. Panel will extend beyond end rafters.
3. Using the lower channel of the 111613Z144 and wire
spring (102198), secure one edge of film panel to
the 111613Z144.
4. With edge secured, spread free/loose edge of panel
out so it hangs down evenly from 111613Z144.
Excess film panel can be rolled onto the roll-up
conduit during the next procedure or trimmed. Do
not trim too much off.
5. Continue with the following procedures to finish the
roll-up side panel installation.
Roll-up Panel
Lower Channel of the
111613Z144
Roll-Up Side Panel Installation
ASSEMBLE ROLL-UP SIDE PANEL CONDUIT
Gather the parts:
‡
Pipe 1.315'' x 147'' swaged (#131S147)
‡
Tek screws (#FA4482B)
The roll-up conduit assembly attaches to the bottom edge
of the roll-up panel. This assembly runs the length of the
frame and serves as the center pipe that the roll-up panel
wraps around when it is opened for ventilation.
Complete these steps to assemble the roll-up side panel
conduit.
1. Locate sections of pipe (#131S147) to assemble the
roll-up panel conduit.
2. Insert the swaged end of each pipe into the plain end
of another pipe until conduit is assembled.
3. Secure each pipe joint with a Tek screw (FA4482B)
and tape over the screw using duct tape. Construct a
conduit that is longer than the building. Conduit is cut
to length in a later procedure.
4. With assistance, place the assembled conduit on the
lower edge of the roll-up side film.
5. Allow 6" of pipe to extend beyond the end rafter
opposite where gearbox will be installed. Allow
approximately 8" to extend beyond the end rafter at
the gearbox end of the frame.
6. Cut the pipe to length at the gearbox end.
ATTENTION: After conduit is cut to length, remainder
of pipe is used for the remaining roll-up conduit.
Count the pipes to verify that you have enough to
complete the assembly of the remaining conduit.
Consult the Twist-of-the-Wrist Assembly procedure on
the next page for diagrams that show an assembled
roll-up side.
7. Continue with the procedure that follows to attach the
conduit to the roll-up side panel.