43
Revision date: 12.02.16
End Frame Assembly
$66(0%/( ,167$//%$&.
END WALL COLUMNS
Consult the end frame diagrams near the back of these instructions
before
you begin. Verify the drawing is for the
BACK end wall, or the plain wall with no openings. Assistance is required to assemble the end frames. The following
steps describe one way to assemble and set the vertical supports. Instructions shown are for both base plates and
ground posts. Follow the applicable instructions for materials included in purchased shelter. See attachment details on
the following page.
GROUND POSTS
1. Consult the end frame layout diagrams and mark the
positions of the vertical supports on the site.
2. Dig an 8"-10" diameter hole at the locations found in
previous step to a depth that is
below the geographic
frost line
. (Minimum depth is 24".)
3. Attach the tops of the end wall columns to the
underside of the rafter using QH1330 brackets and
Tek screws. Adjust as needed to position and plumb.
4. After the vertical supports are in position, plumb,
and the correct distances apart, secure the vertical
supports in the ground holes with customer-supplied
concrete. Concrete should remain at least 2"-4"
below the finished grade level so that it does not
interfere with construction and the installation of other
end frame components, doors, or end cladding.
BASE PLATES
1. Consult the end frame layout diagrams and mark the
positions of the vertical supports on the site.
2. Consult "Mounting Feet Installation" pages to attach
base plates using customer-supplied fasteners.
3. Attach the tops of the end wall columns to the
underside of the rafter using QH1330 brackets and
Tek screws. Adjust as needed to position and plumb.
4. After the vertical supports are in position, plumb,
and the correct distances apart, secure the vertical
supports to the base plates using 1/2" x 3-1/2" bolts
(GS0046), 1/2" nuts (106977), and 1/2" washers
(106953). See details on following page.
Ground Level
6'
6'
6'
6'
6'
ATTENTION:
PART AND
ATTACHMENT DETAILS ON
THE FOLLOWING PAGE.
All dimensions
shown are
center-to-center.
Содержание Growers Supply GrowSpan 500 Series
Страница 22: ...22 Revision date 12 02 16 Frame Assembly 5 0 66 0 FRQWLQXHG Customer supplied rafter spacing jig ...
Страница 65: ...65 Revision date 12 02 16 Roll Up Side Panel Installation ...
Страница 111: ...111 Revision date 12 02 16 Additional Notes Space below is reserved for customer notes ...