FANATEC PODIUM WHEEL BASE DD2, Руководство пользователя

Страница: 43 / 48

43
Problem description Solution
The tuning display does not show anything or is
not working properly. Try to use another steering wheel. If this is also
not working properly the Podium Wheel Base
DD2 might be damaged.
Check the pins inside the Quick Release of
the steering wheel, these must not be bent or
damaged.
After switching on the Podium Wheel Base DD2
the auto calibration is not working properly. Make sure that you have updated your Podium
Wheel Base DD2 to the latest firmware version
which can be downloaded from www.fanatec.com/
support.
After playing a while the Podium Wheel Base DD2
seems to become weaker or is fading. When the motor temperature is close to the upper
limit the Tuning Menu values will be overwritten to
regular maximum values (not higher than 100 %).
Additionally, the motor power level is controlled by
firmware so that the FFB strength may fade in this
high temperature range but the motor will not be
damaged. This allows extending the duration of
driving before the motor has to completely stop
operating to calm down.
Let your Podium Wheel Base DD2 cool down be
-
fore continuing to use it.
After playing a while the Podium Wheel Base DD2
motor has switched OFF.
When the temperature is exceeding the upper lim-
it the motor will be deactivated for a while until the
temperature is low enough (to protect the hard-
ware from damages).
Let your Podium Wheel Base DD2 cool down
before continuing to use it. Contact our customer
support if this happens consecutively.
Fan is always working in full speed even though
the Podium Wheel Base DD2 was just powered
ON and did not heat up due to driving yet.
In case of malfunctioning temperature sensor the
fans will work at maximum speed to protect the
hardware from overheating. Please contact our
customer support. Note: Operating room temper
-
ature: 15°C-35°C
After calibration run at startup of Podium Wheel
Base DD2 the attached steering wheel doesn’t go
to correct centre position.
Please check your Tuning Menu settings, the val-
ue for SPR (spring) must be higher than ‘000’ as
this effect is required to make correct centring.
Default value is ‘100’.