FANATEC PODIUM WHEEL BASE DD2, Руководство пользователя

Страница: 34 / 48

34
and some games even use only one type to create all different feelings. Using
your Tuning Menu in the Podium Wheel Base DD2 you can increase or reduce
these different effects individually.
NOTE:
If SPR is set to low values or ‘OFF’ the Podium Wheel Base DD1
will not be able to move the attached steering wheel to correct centre po-
sition after calibration run.
IMPORTANT:
Only set these values higher than 100% if the force feed-
back effects are clearly not strong enough and weaker in comparison to
other games. When the game sends full effects and the wheel is set to
100%, the device will work at its power limit. Pushing up one value to a
very high number or even raising multiple values will result in higher load
on the motor and increased heat development.
6.3.11 ABS (Brake Pedal Vibration Threshold)
ABS range: 0 … 100 OFF ABS default: OFF
This feature gives you a direct feedback based on your brake inputs. If you set
the value to 100 the vibration will start as soon as you give 100% brake input
to the game. If you set it to 95% the vibration will start if you push the brake to
95% or more. The ABS feature uses the vibration within your wheel rim (can be
turned off by setting SHO to “0”) AND the vibration motor on a CSP (V2 or V3)
pedal set if it is connected directly to the wheel - not individually by USB. ABS
can also be simulated dynamically by the game if the developer makes use of
the Fanatec
®
SDK.
For further information check the FAQ section on our website
www.fanatec.com/support.
6.3.12 SHO (Shock/Vibration)
SHO range: OFF 010 ... 100 SHO default: 100
The strength of the shock / vibration motors inside the Fanatec
®
steering wheel
can be adjusted from 100% to 0%. These vibration motors can be used by a
game directly (Fanatec
®
SDK) or by the ABS function.