FAAC A951, Руководство пользователя

Страница: 51 / 66

A951 51 532081 - RevA
Tr
ansla
tion of the original instruc
tions
ENGLISH
9.5 ERRORS
Errors are malfunctions that prevent the automation
from working. They are indicated by a steady red LED
on the Logic board.
After every 5 minutes in which a fault condition persists
and for a maximum of 20 consecutive times, the A951
will perform a reset to attempt to restore normal oper-
ation so that no action is required if the condition that
caused the error was temporary. If the fault persists,
remove the cause in order to restore normal operation.
In order to carry out a manual reset, see § 7.5.
 18
Errors
When an error occurs:
1. Check all the electrical connections
2. Perform
a reset.
3. If the problem persists, carry out the operations described in the table one at a time until the problem is
resolved.
Error Action required
01 Board failure - Replace the Logic board
02 E 2 prom failure - Replace the Logic board
03
Motor driver failure - Replace the Logic board
- Replace the gearmotor
04 Accessories power supply fault - Check that the accessories power supply is not short circuited
- Check that maximum load of the accessories has not been exceeded
- Replace the Logic board
- Replace the Power board
05
Microcontroller error - Reload/update the Logic board firmware
- Replace the Logic board
07
Motor failure - Replace the gearmotor
-
Replace the Logic board
09 Board voltage anomaly - Replace the Power board
10 Battery discharged or not connected - Wait for a charging cycle to be completed, if the problem persists, replace the battery
11
TEST failed on S1 - Check the connections of the safety device
- Check that the safety device is working
-
Replace the Logic board
12
TEST failed on S2 - Check the connections of the safety device
- Check that the safety device is working
-
Replace the Logic board
15
Set-up inhibited - Make sure that Night or Manual mode has not been set
- Make sure that an emergency command has not been activated
16
Encoder fault - Replace the gearmotor
-
Replace the Logic board
18 Firmware not compatible - Update with the correct firmware
19 High mechanical friction - Make sure that the leaf has been mounted correctly and that it moves smoothly,
remove any friction
- Replace the Logic board
- Replace the gearmotor
The type of error can be identified on the board or
via the KP EVO
ON THE BOARD
When the display of the A951 indicates 11, press the
+ and - buttons simultaneously:
E
r appears on the
display followed by the identification code (
 18
).
ON THE KP EVO
The error code appears on the home page. Go to
menu 5; the display provides information regarding
the current error.