FAAC A951, Руководство пользователя

Страница: 38 / 66

A951 38 532081 - RevA
Tr
ansla
tion of the original instruc
tions
ENGLISH
7.4 SET-UP
The SET-UP procedure consists of a series of move-
ments during which the force, speed and decelera-
tion values during opening and closing are acquired
according to the weight and size of the doors.
Set-up should be performed:
- When the automation is first put into operation.
- After the Logic board has been replaced.
- After any variation in the maximum opening angle,
the weight of the door or the amount of friction.
- After factory defaults have been restored.
SETUP CANNOT be performed in conditions of:
- Emergency active
- MANUAL mode
- NIGHT mode
- DOOR OPENED mode
- Battery operation
!
During the SET-UP procedure, the safety sensors are
ignored, keep at a safe distance and prevent anyone
from approaching the door until the procedure has
been completed.
Both the opening and closing mechanical stops must
be present during the set-up procedure.
To start the SET-UP procedure from the board:
1. Select
the
tl
function in advanced programming.
2. Press the + and - buttons simultaneously until
tl
flashes on the display.
3. Release the buttons and wait for the procedure
to be completed (during the various phases, the
display will show
L0
,
L1
and
L2
in sequence)
4. When finished, the display switches to the auto-
mation status view.
To start the SET-UP procedure via the KP EVO:
1. Select parameter 2.5.2 from the menu.
2. Confirm the selection when requested to do so.
3. Wait for the procedure to be completed (during
the various phases, the display will show
L0
,
L1
and
L2
in sequence).
4. When finished, the display switches to the auto-
mation status view.
7.5 RESET
A RESET consists of initialising the A951, which must be
carried out while an error condition is present in order
to attempt to restore normal operation.
To carry out a RESET via the KP EVO, keep the two
central buttons pressed simultaneously for 5 sec-
onds. Alternatively, temporarily turn off power to
the A951.