Ezgo INDUSTRIAL 1200, Руководство пользователя и руководство по обслуживанию

Страница: 28 / 148

OPERATION AND SERVICE INFORMATION
Page 12
Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
VEHICLE WITH A DISCHARGED BATTERY
To reduce the possibility
of severe injury or death
from inadvertent motion,
do not attempt to ‘jump start’ a vehicle.
The vehicle is equipped with a starter/generator and
does not idle. When starting the engine, the starter/gen-
erator functions as a starter and with the engine running,
it functions as a generator.
With the short running times associated with this kind of
vehicle, the generator is more than adequate to maintain
the battery charge level. The generator is not designed to
charge a discharged battery.
When engine starts, the clutches engage and cause
vehicle to move making ‘jump starting’ both dangerous
and impractical.
If the vehicle battery has become discharged, it must be
charged using a 12 volt charger that is rated at 10 amps
or less. Read and understand all instructions provided by
the manufacturer of the charger.
TRANSPORTING VEHICLE
TOWING
T h i s v e h i c le i s n o t
designed to be towed.
It is recommended that the vehicle be moved by placing
the entire vehicle on a trailer, flatbed truck or other suit-
able transport.
NEUTRAL LOCK
To prevent the driven clutch from turning the rear wheels
during service operations, a neutral lock is located on the
direction selector.
To operate:
Turn key switch to ‘OFF’ and lift seat. Pull out and rotate
the neutral lock pin handle so that the pointed portion of
the handle is to the side of the direction selector cam
(Ref. Fig. 20 on page 12). Move direction selector
towards the area between ‘F’ and ‘R’. During that motion,
the pin will snap into the hole in the direction selector
mounting bracket preventing any movement. When in
this position, the direction selector remains locked in the
neutral position. To unlock the direction selector, pull the
neutral lock pin handle out and rotate until the pointed
portion of the handle fits into the hole in the direction
selector cam.
HAULING
To reduce the possibility
of severe injury or death
while transporting vehi-
cle:
Secure the vehicle and contents.
Never ride on vehicle being transported.
Always remove windshield before transporting.
Maximum speed with sun top installed is 50 mph
(80 kph).
Fig. 19 Tail and Brake Light Bulb Replacement
Rear
Fender
Tail/Brake
Light
Roll Rubber
Bezel Away
From Body
Ref Tlr 2
! !
! !
Fig. 20 Neutral Lock
Unlocked
To
Lock
Hole in Direction
Selector Mounting
Bracket
Hole in Direction
Selector Cam
Neutral Lock
Pin Handle
1
2
Ref Nlk 2
! !