Ezgo INDUSTRIAL 1200, Руководство пользователя и руководство по обслуживанию

Страница: 22 / 148

OPERATION AND SERVICE INFORMATION
Page 6
Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
OPERATING THE VEHICLE
Improper use of the vehicle or the lack
of proper maintenance may result in
damage or decreased performance.
Read and understand the following warnings before
attempting to operate the vehicle.
To reduce the possibility
of severe injury or death
resulting from loss of
vehicle control, the following warnings must be
observed:
When driving vehicle, consider the terrain, traffic
conditions and the environmental factors which
effect the terrain and the ability to control the
vehicle.
Use extra care and reduced speed when driving
on poor surfaces, such as loose dirt, wet grass,
gravel, etc.
Stay in designated areas and avoid extremely
rough terrain.
Maintain a safe speed when driving down hill. Use
service brake to control speed when traveling
down an incline. A sudden stop or change of
direction may result in loss of control.
Slow down before and during turns. All turns
should be made at reduced speed.
Never drive vehicle up, down, or across an incline
that exceeds 14° (25% grade).
To reduce the possibility
of severe injury or death
resulting from improper
vehicle operation, the following warnings must be
observed:
Refer to GENERAL SPECIFICATIONS for seating
capacity.
Depressing accelerator pedal will release foot
operated park brake and may cause inadvertent
vehicle movement. Turn the key to the ‘OFF’ posi-
tion whenever the vehicle is parked.
To prevent inadvertent movement when the vehi-
cle is to be left unattended, engage the park
brake, move direction selector to forward posi-
tion, turn key to ‘OFF’ position and remove key.
Make sure that the direction selector is in correct
position before attempting to start the vehicle.
Always bring the vehicle to a complete stop
before shifting the direction selector.
Do not take vehicle out of ‘gear’ while in motion
(coast).
Check the area behind the vehicle before operat-
ing in reverse.
All occupants must be seated. Keep entire body
inside vehicle and hold on while vehicle is in
motion.
RUN-IN
Check for oil or fuel leaks that could have developed in
shipment from the factory. Avoid full throttle starts and
rapid acceleration until the engine has achieved operat-
ing temperature.
All engines consume more oil than normal during the first
hours of operation. As internal moving parts are run-in,
oil consumption should gradually decrease until the rate
of consumption stabilizes.
Check the oil level per the Periodic Service Schedule.
Add oil if the level on the dipstick indicates that oil is in
the add oil range (Ref. Fig. 21 on page 14).
Do not overfill engine. Too much oil
may cause smoking or allow oil to enter
the air filter enclosure.
Both the oil dipstick and fill cap must be in
place before operating the engine. Failure to
install the dipstick and fill cap will result in oil becoming contam-
inated and/or being discharged into the engine compartment.
The oil should be changed in accordance with the Peri-
odic Service Schedule while the engine is warm. See
SERVICE AND MAINTENANCE for checking oil level
and changing oil procedures.
COLD STARTING
Starting a cold engine
may
require use of the choke.
Depress the accelerator approximately 1" (2.5 cm) or
until the starter just begins to operate. Pull the choke out
! !
! !
Fig. 13 Check Oil Level on Dipstick
Maximum oil level
DO NOT OVERFILL
Safe
operating range
Add
oil
Full
Ref Dsk 1