EZ-ACCESS PATHWAY 3G SS06VP, Инструкция по сборке

Страница: 33 / 74

Page 33 of 74
4.6. INSTALL STANDARD PLATFORM HANDRAILS
4.6.1. Regardless of the handrail style, but depending on the configuration, refer to
FIG. 4.10 and FIG. 4.11 as needed.
4.6.2. Pre-assemble the platform handrail for both sides of a straight configuration and the
“first ″ handrail of a turn configuration as described above. Make sure the unattached
legs of the angle posts are on the same side with respect to the handrail tubes, curb
and pickets and pointing outward as shown.
4.6.3. For the “second ″ handrail in a turn configuration, only assemble one angle post as
described above paying attention to how it will connect to the “first ″ handrail so the
angle post will be oriented correctly.
4.6.4. For straight platform configurations and the “first ″ handrail on a turn platform, drop
platform handrails into the corner pockets (FIG. 4.10). The curb should rest on top of
the corner pocket when installing the Two-Line and Single-Line handrails. For the
Vertical Picket and Horizontal Picket handrails, align the bottom of the post with the
bottom of the platform corner pockets.
4.6.5. For the “second ″ handrail on a turn platform, insert the angle post into a corner
pocket at 90° from the “first ″ handrail, then install 5/16”-18 x 1” long hex bolts
through a 5/16” flat washer, the angle post in the “first” handrail and into a 5/16”-18
threaded inserts in the “second” handrail, curb or picket (FIG. 4.11). Tighten all
fasteners securely.
4.6.6. Tighten two each set screws on the inside of the platform corner pocket with a 3/16 ″
Allen wrench.
4.6.6.1. One setscrews is located above the platform deck and the other is
underneath (FIG. 410).
4.6.7. Install the plastic angle caps on top of all handrail posts.
4.6.7.1. Glue in place using construction adhesive as needed.
4.6.8. Tighten all fasteners securely if not done in earlier steps.
FIG. 4.10