Page 20 of 74
3.3.
ATTACH RAMP LEGS TO RAMPS
3.3.1.
Locate the appropriate PRLxxPR (RAMP LEG PAIR where “xx” denotes the leg length)
for the location. Insert the leg into a foot. Make sure the leg is fully engaged in the
foot and the foot will be oriented so it extends under the ramp once installed.
Tighten the thumb screw on each foot securely (FIG. 3.5).
If installing on soft soil it may be necessary to set the foot on a concrete pad.
FIG. 3.5
3.3.2.
Place the slot in the ramp leg over the two shorter studs in the middle of the center
saddle bracket, install the support plate over both studs then install 5/16”-18 nylon
insert locknuts and 5/16” flat washers on each stud but do not tighten fully. Repeat
on the opposite side (FIG 3.5)
In situations where the lower end of a ramp or ramp run is too close to the
ground to install normal feet and feet are needed due to ground or other
conditions, special welded low profile feet (part no. PRLPRLP). are available (FIG
3.6).
3.3.3.
Remove the 5/16”-18 nylon insert locknuts and 5/16” flat washers attaching the
ramp handrail post (if already installed), position the low profile foot so the foot is
oriented under the ramp and the channel leg wraps around the ramp post. Reinstall
the locknuts and flat washers, adjust height as described below then tighten
fasteners securely. Repeat on the opposite side (FIG. 3.6).
Содержание PATHWAY 3G SS06VP
