Page 14 of 74
The feet can be oriented in other directions if necessary due to site conditions
but may present a tripping hazard if not oriented under the platform.
It is the installer’s responsibility to install the system in a manner which is safe
for the persons on and around the system and clearly mark any hazards created
by the installation.
2.2.7.
Make sure the feet are fully engaged on the tubes and tighten the thumb screw on
each foot securely.
If installing on soft soil it may be necessary to set the base foot on a concrete
pad.
2.2.8.
Adjust the final height of the platform by adjusting legs, one at a time, by loosening the
outer set screws in the platform corner pockets. Using a level, adjust the platform
height and re-tighten.
2.2.9.
Once the final height has been adjusted, tighten the second, lower set screw in each
platform corner pocket.
2.2.10.
To allow access to the lowermost hole in the platform post, the support tubes must not
extend more than 1/2” above the platform corner pockets. Trim the support tubes as
needed before installing plugs.
2.2.11.
Insert a plug into the top of each support tubes. Use a rubber mallet or similar tool as
needed (FIG.2.5).
2.2.12.
Ensure all set screws are tightened securely.
2.3.
CONNECT TWO PLATFORMS TOGETHER
2.3.1.
Assemble the first platform as described in the previous steps except on the side where
the second platform will connect, install two PPPC (CONNECTOR – PLATFORM TO
PLATFORM) before installing feet onto the support tubes.
2.3.2.
Make sure the platform connector set screws are oriented outward so they will be
accessible.
Any two platforms of the same width can be connected. However, two 5' x 4’
platforms are usually connected to make a turn back platform.
2.3.3.
Slide the platform connectors up until they contact the bottom of the platform and
tighten the set screws securely (FIG. 2.6).
2.3.4.
Install a support tube stub into the open pocket in each connector until the bottom of
the stub is flush with the bottom of the connector and tighten the set screws securely.
2.3.5.
Install a plug in the top of each support tube stub.
2.3.6.
Assemble the second platform as described in the previous section except only install
support tubes, plugs, and feet on the opposite side of where the platforms will connect
(FIG. 2.7).
2.3.7.
Lift the second platform and slide the open corner pockets over the support tube stubs
extending up from the platform connectors. Tighten the set screws in the platform
corner pockets securely.
2.3.8.
Adjust the platform heights and level as needed.
Make sure all the set screws in both the platform corner pockets and the
platform connectors are tightened securely before proceeding with the
installation.
Содержание PATHWAY 3G SS06VP
